If you place your order by phone, please provide the customer service representative with promotion code "MT" to apply any sale pricing that may be available through this promotion. This Promotion may include products that are not discounted below our normal competitive pricing structure.
Promotion effective from October 1, 2009 through November 13, 2009
| Fuel Injectors and Seal Kits 
A poor running car that otherwise has a good tune is sometimes hard to diagnose. Injectors will flow fuel for many years without wear but as the car gets over 200k miles it may be time to test them.
Use water to spray around the injectors to test for a bad injector seal. A momentary decrease in idle speed indicates that the seals are bad. A bad seal will cause a vacuum leak and will cause a lean condition. Replace the seals and reset the fuel mixture for best power and economy.
An engine that is rough at idle but clears up on acceleration may have a worn injector. On LH cars just disconnect the injector plug to find the injector that is not firing. Replacing it will smooth the idle and give more power on acceleration.
| 240 series | B20F | 1975 | K-Jetronic injector, seals not included | Bosch | MT-0437502003 | Reg. $50.00 | | Each | | A. 240 series | B21F, B21FT | 1976-85 | K-Jetronic injector, seals not included | Bosch | MT-0437502015 | Reg. $57.43 | | Each | | B. 240 series | B21F, B21FT | 1976-85 | plastic injector holder/insulator for K-Jet | | MT-463864 | Reg. $7.18 | | Each | | 240 series | B20 | 1975 | fuel injector seal kit (K Jet.) all 8 seals | | MT-2D0200K | Reg. $16.00 | | Each | | D. 240 series | B21, B21FT | 1976-85 | fuel injector seal kit (K Jet.) all 8 seals | | MT-2D0300K | Reg. $4.00 | | Each | | E. 200, 700 series | B23, B230F/FT | 1982-95 | fuel injector seal kit (LH Jet.) all 8 seals | | MT-2D0400K | Reg. $10.00 | | Each | | 700 series | B230FT | 1985-89 | LH Jetronic injector (seals included) | Bosch | MT-0280150357 | Reg. $185.00 | | Each | | 960 | 6 cyl | 1992-97 | LH Jetronic injector seal kit | | MT-2D0450K | Reg. $15.00 | | Each |
*If you’re unsure of what type of injectors you need, give us a call and we’ll make sure you get the right ones for your Volvo. Injector seals aren’t included except for
LH injectors which include seals. Always replace injector seals when replacing an injector. |
Fuel Pressure Regulator
The pressure regulator controls the fuel system pressure to the injectors. It is controlled by a vacuum line to the intake manifold. When the regulator is operating correctly it will maintain some residual pressure in the fuel system when the engine is shut off. When the engine is running it will modify the fuel pressure to ensure proper fuel/air ratio is maintained regardless of throttle position.
| Fuel Pressure Regulator | 1982 240 series with B23F | Bosch | MT-0280160213 | Reg. $80.77 | | Each | | Fuel Pressure Regulator | 240 series with B23F & B230F 1983-1987 | Bosch | MT-0280160293 | Reg. $64.78 | | Each | | Fuel Pressure Regulator | 1988 240 series B230F LH 2.2 | Bosch | MT-0280160292 | Reg. $63.75 | | Each | | Fuel Pressure Regulator | 1989-1993 240 series B230F LH 2.4 | Bosch | MT-0280160294 | Reg. $58.08 | | Each |
|
| Engine Mounted Sensors 
As the overhead cam engine family gracefully ages, we have begun to carry a few of the engine sensors. The sensors on these motors have proven to be very robust and are more likely to be damaged during maintenance work than to wear out. Most sensors can be easily checked with a multimeter. Specs are listed in better manuals. All senders/contacts are located on the left-hand side of the cylinder head and block except for the oil pressure sensor which is on the righthand side of the block near the front.
| A. 240 series non-turbo | 1983-88 | fuel injection temperature sensor (4 cyl) - light blue | | MT-1332396 | Reg. $13.44 | | Each | | B. 240 series | 1982 | constant idle temperature sensor - white | | MT-1306937 | Reg. $33.77 | | Each | | 240 series turbo - B21FT | 1982-85 | constant idle temperature sensor - white | | MT-1306937 | Reg. $33.77 | | Each | | D. 240 series non-turbo | 1976-82 | thermo time switch for cold start system | | MT-1219731 | Reg. $144.21 | | Each | | D. 240 series turbo | 1981-85 | thermo time switch for cold start system | | MT-1219731 | Reg. $144.21 | | Each | | E. All B20, B21, B23 | 1975-84* | oil pressure switch (push-on spade connector type) | | MT-1606877 | Reg. $5.37 | | Each | | F. All B230, B234 | 1985-up* | oil pressure switch (push-on bullet connector type) | APA | MT-1347003 | Reg. $3.33 | | Each | | G. 240 series | 1975-93 | water temperature sensor for temperature gauge | | MT-460191 | Reg. $10.08 | | Each | | H. All 4-cylinder | 1989-95 | crank speed sensor | Bougicord | MT-271949 | Reg. $38.36 | | Each | | I. 240 series turbo | 1981-85 | thermo wax valve | | MT-1269355 | Reg. $81.30 | | Each |
*Not for dual terminal senders used on turbos or other models with oil pressure gauge. |
Promotion effective from October 1, 2009 through November 13, 2009
